Electric Clutch Kit - Landoll SSB-8 Operator's Manual

ASSEMBLY INSTRUCTIONS

Electric Clutch Kit

The clutch is controlled by a toggle switch mounted to the
tractor by a hook and loop fastener.
Clutch characteristics are as follows:
1. The clutch is disengaged when power (12 volts) is
applied. If there is a power failure or electrical
problem, the seeder will continue to operate and the
implement must be raised to stop seeding.
2. Seed shafts will not rotate when implement is backed
up.
3. The Switch box contains a standard 5 amp fuse.
4. The clutch must be disengaged (power applied)
when seed shafts are turned manually for calibration.
5. Check that the clutch case has proper clearance
between rubber bumper stop. Improper clearance
may prevent the clutch from engaging or
disengaging. See Figure 2-19.
2-18
6. Connect clutch wiring harness to clutch lead, and
route wire along frame and drawbar. Secure to frame
and drawbar or with hydraulic hoses and warning
light harness by cable ties or adhesive mounts.
7. Install switch on tractor in a convenient location with
the Hook and Loop included or other type of mount
(not included).
8. Attach the wire lead to power source and secure
wire.
9. Check clutch operation: Clutch will disengage when
power is applied. (Clutch will make a clicking sound).
Set seeder on the ground and drive a short distance
while turning switch "SEED" and "NO SEED". The
seed cup shaft will stop rotating when switch is
turned to "NO SEED" position.
10. Turn switch to "SEED" position when seeder is not
used to shut off power to prevent possible
overheating of clutch coil. (In "SEED" position No
Power is supplied to Clutch.)
At no time use high pressure water or air to clean the
clutch as damage could occur.
Figure 2-19: Electric Clutch
1P480rev0718