Avaya IX Collaboration Unit CU360 Release Notes page 38

© 2019 Avaya Inc. All rights reserved.
Post-Provisioning an Endpoint
If you don't have the code for a specific endpoint, because it has not yet been provisioned in
Avaya Equinox® Management, you can insert the Server Service Code of your Avaya
Equinox® Management, and leave the Endpoint Service Code digits empty or all zeroes
(post-provisioning code). This feature is called Post-Provisioning. In this case the Avaya
Equinox® Management Admin will be notified that an endpoint, not yet provisioned, has
been added to the list of the manageable endpoints and can be configured any time later.
This way, an IT administrator can plug all the endpoints in all the company conferencing
rooms, just inserting the same post provisioning code; then set a mnemonic name for the
endpoint and configure it later in Avaya Equinox® Management, where it will be displayed
with a red clock icon near the name.
You can then specify a set of basic/advanced settings for an endpoint or delete the endpoint
if you don't want to provision it any longer.
Post-provisioned Endpoint Listed
Auto Provisioning FAQ
[Q]What is the default for Auto-provisioning in Avaya IX video endpoints?
[A]The default depends on the installation of the endpoint and if it was already managed by
an Avaya Equinox® Management entity. If the endpoint is a newly installed endpoint or it
was not managed, the default will be "Cloud"; otherwise it will be "Local". The Local Mode
will be automatically changed to "Cloud" when the Avaya Equinox® Management entity
managing the endpoint is updated to solution release 9.0, if Auto-Provisioning is enabled.
[Q]How to check if my endpoint is managed through the cloud or not?
[A]Check Configure>Advanced>Utilities>Remote Access>Avaya Equinox® Management
If the connection Mode is "Cloud", your endpoint is connected to Avaya Equinox®
Management using a secure web socket. Status of the connection is visible in the endpoint
Web home page or in System Status> More.
Cloud Mode – Connected
[Q]What happens if I load factory defaults on a provisioned endpoint?
[A]Your endpoint will remember the Service Code inserted for Provisioning and will propose
it again (only the first 5 digits are needed). Just press "Next" in the initial wizard to have
you're the endpoint configured again with the same Avaya Equinox® Management.
[Q]How can I associate my endpoint to a different Management Server with auto
provisioning?
© 2015 Avaya Inc. All rights reserved. NDA Confidential, Use pursuant to your agreement.
•
Mode: Cloud (Connection using auto-provisioning)/ Local (Connection to Scopia
Management 8.3 version or earlier, or Endpoint Auto-provisioning not enabled
in Equinox Management)