Festo Compact Performance Series Programming And Diagnosis page 22

1. Installation
Preparing the When you have selected suitable cables, connect them
cables as follows:
1. Loosen the centre knurled nut to open the socket.
!
"
Fig. 1/6: Preparing the connecting cable
2. Open the strain relief on the rear of the housing.
3. Remove 5 mm of the insulation from the cable and
4. Connect the ends of the conductors.
5. Replace the connecting part on the housing of the
6. Tighten the strain relief.
CP-CO 9905a
!
Cable
Housing
Connecting part
Strain relief
Then pass the cable through as described below.
fit end sleeves to the wire strands.
socket. Pull the cable back so that it is not looped
inside the housing.
"
1-13