Festo Compact Performance Series Programming And Diagnosis page 17

1. Installation
The following station numbers are permitted: 1; ...; 98
PLEASE NOTE
You must observe any possible limitations imposed
by the CANopen master in respect of the station
numbers.
Proceed as follows:
1. Switch of the operating voltage.
2. Assign an unassigned station number to the
3. Use a screwdriver to set the arrows of the address
UNITS
TENS
UNITS
TENS
Fig. 1/4: Examples of address settings
1-8
CP valve terminal.
selector switches to the units or tens figure of the
desired station number.
Setting for field bus address: 05
Setting for field bus address: 38
CP-CO 9905a