Host / Bus In - Leuze electronic 50126970 Original Operating Instructions

Function as switching output
1
1
2
3
Figure 7.8: Switching output connection diagram SWIO_1 / SWIO_2
NOTICE
Each configured switching output is short-circuit proof! Do not load the respective switching output of the
device with more than 60 mA at +10 ... +30 V DC in normal operation!
By default, the two switching inputs/outputs SWIO_1 and SWIO_2 are configured so that they
function as switching inputs. Switching input SWIO_1 activates the start reading gate function
and switching input SWIO_2 activates the reference code teach-in function.
The functions of the individual switching inputs/outputs are programmed via the display or via configuration
in the webConfig tool under the Switching input or Switching output heading (see chapter 10 "Starting up
the device - Configuration").
7.5

HOST / BUS IN

The device makes an Ethernet interface available as host interface.
2
3
1
4
Figure 7.9: Host/Bus In, M12 socket (D-coded)
Table 7.4:
Pin Name
1 TD+
2 RD+
3 TD-
4 RD-
Thread FE
 For the host connection of the device, the "KB ET - ... - SA-RJ45" ready-made cables are preferred
(see table 16.3).
Leuze electronic
Switching output
Switching output from controller
Switching input to controller (deactivated)
Pin assignment HOST / BUS IN
Comment
Transmit Data +
Receive Data +
Transmit Data -
Receive Data -
Functional earth (housing)
BCL 608i
Electrical connection
2
3
32