Ap (Api Enable); Bd (Baud Rate) - Digi XTend vB DigiMesh XTP9B-DPM-001 User Manual

Parameter
1
2
Default
2

AP (API Enable)

The API mode setting. The device can format the RF packets it receives into API frames and send them out
the serial port.
When you enable API, you must format the serial data as API frames because Transparent operating mode
is disabled.
Parameter range
0-2
Parameter
0
1
2
Default
0

BD (Baud Rate)

Set or read the serial interface baud rate for communication between the serial port of the device and the
host.
XTend vB DigiMesh RF Module User Guide
Description
API Explicit Rx Indicator - 0x91, this is for Explicit Addressing data frames.
XTend DigiMesh API Rx Indicator (0x80)
Description
Transparent Mode. All UART input and output is raw data and the device uses the RO and
RB parameters to delineate packets.
API Mode Without Escapes. The device packetizes all UART input and output data in API
format, without escape sequences.
API Mode With Escapes. The device is in API mode and inserts escaped sequences to
allow for control characters. The device passes 0x11, 0x13, 0x7d, and 0x7e as data.
Serial interfacing commands
53