Entering Account Codes When Placing Calls - Toshiba Strata CS User Manual

Entering account codes when placing calls

C 3. P
HAPTER LACING
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
Note:
See "Placing calls to an IP address" on page 3-6 for information
on entering the IP address.
In the U.S. if you want to call the external phone number
Example:
must dial (the usual access code) before you dial
9
the Internet, you must dial a different access code.
When you dial an external number, you may notice a delay before you hear the
number ringing. To eliminate this delay, press
Depending on your office's configuration, you may be prompted to enter an
account code when you place external calls. Even if you are not prompted for an
account code by the system, your office may require you to enter one. Your Strata
CS system administrator can tell you what account codes, if any, you must use.
If you are prompted to enter an account code
If you are prompted to enter an account code when you place a call, you will hear
one of the following prompts:
A beep.
n
"Please enter account code."
n
A double beep. This indicates that you are dialing a contact who has an
n
associated account code. See "To enter a contact's name and basic
information" on page 15-5.
When you hear the prompt, enter the account code followed by
double beep, you can enter a new account code or press
associated code.
Depending on how your Strata CS system administrator configured your system,
the prompt may occur either after you dial the access code or after you dial the
phone number. If the prompt occurs after you dial the access code, enter the
account code followed by
example:
[prompt]
9 8812 # 212 123 4567
where is the access code,
9
the area code and phone number.
C P
ALLS ON THE HONE
after dialing the number.
#
, and then continue entering the phone number. For
#
is the account code, and the numbers after
8812
555 1212,
. To place a call over
555 1212
. If you hear the
#
to use the contact's
#
you
are
#
3-3