Advertisement
When using NetWare
Follow the installation procedure described in the
instruction manual to ensure that the installation is
done properly.
About expansion of optional RAID controller D
When you use Server Setup Tool to setup the server
with RAID controller D (MR466), the [Detailed Setup]
option may not setup right. To set RAID configuration
details with Server Setup Tool, use the following
procedure.
(1)
(2)
5.1
When the message [Press <Ctrl><M> to Run
MegaRAID Configuration Utility] is displayed during
the server boot, press [Ctrl]+[M]. After MegaRAID
Configuration
configuration
Drive]-[Advanced
[WRTHRU] to the array that is installed on the OS.
For
operation
Configuration Utility, refer to MegaRAID User's
manual.
After setting RAID configuration details, insert the
Server Setup Tool CD-ROM and the Startup Disk
floppy disk in the CD-ROM drive and the floppy disk
drive respectively, then restart the system to start
the Server Setup Tool.
Utility
is
started,
in
detail,
and
Menu]-[Write
procedures
4/15
set
RAID
select
[Logical
Policy],
about
MegaRAID
S00047-EN EH02 Rev. E
set
Advertisement
