Deep-Hole Drilling - Cycle83 - Siemens SINUMERIK User Manual

12.4.5

Deep-hole drilling - CYCLE83

Programming
CYCLE83 (RTP, RFP, SDIS, DP, DPR, FDEP, FDPR, DAM, DTB, DTS, FRF, VARI, AXN, MDEP, VRT, DTD, DIS1)
Parameters
Parameter Data type
RTP REAL
RFP REAL
SDIS REAL
DP REAL
DPR REAL
FDEP REAL
FDPR REAL
DAM REAL
DTB REAL
156
5. Confirm your settings with this softkey. The cycle is then automatically transferred to the
program editor as a separate block.
Description
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Final drilling depth (absolute)
Final drilling depth relative to the reference plane (enter without sign)
First drilling depth (absolute)
First drilling depth relative to the reference plane (enter without sign)
Amount of degression (enter without sign)
Values:
>0: degression as value
<0: degression factor
=0: no degression
Dwell time at drilling depth (chip breakage)
Values:
>0: in seconds
<0: in revolutions
Programming and Operating Manual (Turning)
01/2017