Nilfisk-Advance Advance Retriever 2060 Service Manual page 97

13 See Figure 5. Connect Hose (3) to Connector (2) as shown. Route Hose (3) alongside the existing hydraulic hoses from the Main Broom Motor,
bring it up through the mounting bracket for Valve Assembly (T).
14 Disconnect Hose (U) from the Valve Assembly (V). Install Tee (4) as shown and reconnect Hose (U) to the end of the tee.
15 Route Hose (3) up and over the hydrostatic pump and connect to Tee (4) as shown. NOTE: Make sure the hose is clear of all moving parts, use
cable ties to secure if needed.
16 After assembly is complete, test machine for any hydraulic fluid leaks.
NOTE: If needed, Seal Kit PN 56479577 can be installed in conjunction with this kit.
3
FIGURE 4
U
FRONT
(page 3 of 3)
3
4
V
T
5/00 revised 11/00 Form No. 56040713