Nilfisk-Advance Advance Retriever 2060 Service Manual page 121

13 Raise and prop the hopper and remove the access panel to the left of the operator's seat.
14 See Figure 8. Route end (G) of the Harness (1) up through the Protective Sock (H) inside which the hydraulic hoses are routed.
15 Connect Plug (I) to the connector that the original Interlock Switch was connected to.
16 Route Plug (J) through the Hole (K) directly next to the connector which Plug (I) is connected to. Pull this part of the Harness (1) as far into the
adjoining compartment as it will go.
17 Slide the Strain Relief (5) onto the portion of the Harness (1) that you pulled up through the protective sock as shown and tighten. NOTE: Install
the Strain Relief (5) at a point on the harness that allows just enough cord to reach the strain relief mounting point on the hopper (.59" / 15.08mm
hole drilled in step 5).
18 Insert these wires through the .59" (15.08mm) hole drilled in step 5.
19 Lower the Hopper and install the nut for the Strain Relief (5) and tighten. Install Connector (6) onto the ends of these wires and plug into the switch
assembly installed in step 12. Use Cable Ties (10) as needed.
20 Route the remaining end of the Harness up over the horn and plug into the Switch Assembly (L) installed in step 4. Use Cable Ties (10) as
needed.
21 Re-install the access panel in the operator's compartment.
FIGURE 8
J
H
K
I
(page 7 of 8)
FRONT
L
5
G
3/01 Form No. 56040742
6