Nilfisk-Advance Advance Retriever 2060 Service Manual page 113

1 See Figure 1. Use the dimensions shown as a guide to mark the location for the large hole for mounting the air inlet.
2 Drill or cut out the large 2.375" (60 mm) diameter hole.
3 Insert the Flange Weldment (B) into the hole. Use the flange as a template to mark the location for the two .281" (7 mm) diameter holes. Remove
the flange and drill the two holes.
4 See Figure 2. Fasten the flange weldment into the hole of the hood using the supplied Screws (E) and Nuts (D).
5 Disconnect the flexible air inlet Hose (F) from its current position (attached to chassis channel at tube "H"), by loosening Hose Clamp (G).
6 Connect the flexible air inlet hose to the inlet flange weldment, and secure using the original Hose Clamp (G).
7 Place the Inlet Hood (C) onto the Flange Weldment (B), this completes the installation.
FIGURE 1
(88 mm)
16 in.
(406 mm)
© 2000 Printed in USA, Nilfisk-Advance, Inc.
56419321 AIR INLET HOOD KIT
For Retriever™ 2060 and Nilfisk SR 1800
ITEM PART NO.
56040738
A 56419313
INSTALLATION INSTRUCTIONS
FRONT
3.5 in.
1.75 in.
(44 mm)
6 in.
(152 mm)
CONTENTS OF KIT
QTY DESCRIPTION
1 Instruction Sheet
1 Inlet Hood Assembly
(page 1 of 2)
2X
Ø .281 in. (7.1 mm)
Ø 2.375 in. (60.3 mm)
10/00 Form No. 56040738