Nilfisk-Advance Advance Retriever 2060 Service Manual page 110

ITEM
A
B
C
D
E
ITEM
A
B
F
G
Removal
1 Disconnect the battery.
2 Open the left side door and the engine cover.
3 See Figure 1. Remove and save the hardware items (H), that secure the oil cooler's hydraulic hoses.
4 Loosen slightly the hydraulic hose at point (J). Then tip the oil cooler up and out of the way.
5 Drain the engine coolant at the radiator's drain plug.
6 Remove the engine cooling fan, (3) screws.
7 Remove two Screws (K), Screw and Nut (W), and three Screws (L). Disconnect the Bar (M) from the Radiator Mount Weldment (N) then take the
mount weldment out of the machine. Save the hardware for installing the new radiator mount weldment.
8 Separate the lower coolant Hose (O) from the engine by removing Hose Clamp(s) (P).
9 Loosen Hose Clamp (Q) on Hose (R) and disconnect from the radiator.
10 Take out the Screws (S) mounting the radiator into the machine.
11 Disconnect the radiator overflow hose from the radiator.
12 Pull the radiator and shroud out of the machine together.
© 2000 Printed in USA, Nilfisk-Advance, Inc.
56419304 4 TUBE RADIATOR "T.U." KIT
™
For Retriever 2060 (gas, propane & dual fuel with tip-up oil cooler)
and Nilfisk SR 1800 (gas, propane & dual fuel)
CONTENTS OF KIT
PART NO. QTY
56040733 1
56419277 1
56418605 2
56419287 1
56419284 1
56418227 1
56419305 4 TUBE RADIATOR "D" KIT
™
For Retriever 2060 (diesel) and Nilfisk SR 1800 (diesel)
CONTENTS OF KIT
PART NO. QTY
56040733 1
56419277 1
56418605 2
56419282 1
56419280 1
INSTALLATION INSTRUCTIONS
DESCRIPTION
Instruction Sheet
Radiator, 4 Tube
Gasket, Bulb
Shroud Weldment G
Radiator Mount Weldment G
Hose, Lower Radiator
DESCRIPTION
Instruction Sheet
Radiator, 4 Tube
Gasket, Bulb
Shroud Weldment
Radiator Mount Weldment
(page 1 of 3) 9/00 Form No. 56040733