Nilfisk-Advance Advance Retriever 2060 Service Manual page 75

30 See Figure 5. Install the Tail Lights (5) and Tail Light Brackets (6) as shown re-using the Screws (G) from the tail light covers (the wires from the
tail lights should be routed through the holes in the center of the brackets). Use the (4) self-tapping Screws (30) to mount the Tail Lights to the
Brackets. Connect the ground wire from each tail light to one of the mounting Screws (G) for the Tail Light Brackets (6).
31 Remove the control panel console and set to the side.
32 Drop the Tail Light Harness (15) down through the opening at the rear of this compartment as shown. Make sure the connectors with the following
wire colors are on the left side: (GRA, WHT/VIO, BLU/BLK, WHT). The connectors with the following wire colors should be on the right side:
(BLU/BLK, WHT, WHT/VIO, VIO/YEL).
33 At the very back of this compartment there are (2) large 6 pin connectors plugged together. Unplug these (2) connectors and connect the (2) large
6 pin connectors from the Tail Light Harness (15) between them.
34 Re-install the console assembly.
35 Route the wiring harness through the (2) (H) Holes in the chassis as shown.
36 Connect the Tail Light Harness (15) to the Tail Lights (5).
37 Re-install the fuel tank and fuel tank guard weldment (if removed).
5
30
FIGURE 5
H
G
6
5
(page 5 of 6)
15
G
6
5/99 revised 7/01 Form No. 56040692