Nilfisk-Advance Advance Retriever 2060 Service Manual page 89

3 See Figures 2 and 3. Check your machine for holes in the locations where the Wand Hanger (16) will mount (right rear panel of hopper assembly)
and where the Wand Retainer (21) mounts (right side of bumper). Later machines have pre-drilled holes. If your machine has pre-drilled holes
skip steps 4-6. If your machine does not have pre-drilled holes you will need to follow steps 4-6.
4 See Figure 2. Use the dimensions shown to find and mark the location for the (2) wand retainer mounting holes. Drill the holes to Ø.224" (5.69
mm) in the right top bumper corner.
5 See Figure 3. Use the dimensions shown to find the location for the (2) wand hanger mounting holes. Drill the holes to Ø .344" (8.74 mm).
6 Use the dimensions shown to find and mark the location for hole (A). This is where the end of Control Cable (8) will go through to connect to the
Butterfly Assembly (15). Drill the hole to a diameter of .375" (9.53 mm).
FIGURE 2
FRONT
FIGURE 3
FRONT
10
21
9.63"
(244.5 mm)
9.13"
(231.9 mm)
(79.8 mm)
(page 2 of 5)
6.39"
(162.3 mm)
3.56"
(90.4 mm)
Ø .224"
(5.69 mm)
Ø .344"
(8.7 mm)
3.37"
(85.7 mm)
14.91"
(378.7 mm)
3.14"
4/99 revised 7/01 Form No. 56040701
1.43"
(36.5 mm)
1"
(25.4 mm)
3.50"
(88.9 mm)
A
Ø .375"
(9.5 mm)