Nilfisk-Advance Advance Retriever 2060 Service Manual page 118

6 See Figure 4. Install Screw (11) and the (2) (12) Jam Nuts as shown. NOTE: This bolt actuates(closes) the Switch (7) installed in step 4 when
the hopper is lowered.
FIGURE 5
D
11
C
A
E
7 See Figure 5. Remove the (A & B) Nuts from the old Switch
Actuator Assembly. NOTE: The linkage arm that these two
nuts are attached to is protruding out the back of the hopper.
8 Lower the hopper and open the dump door.
9 Open the hopper cover and remove the Dust Control Filter
and the Panel directly under the filter.
10 Remove the Switch Actuator Assembly (C) from the hopper.
Re-install the bottom (2) (D) Mounting Screws to plug the
B
holes. Leave Grommet (E) in the hopper back panel.
(page 4 of 8)
FRONT
12
3/01 Form No. 56040742
FIGURE 4