12
See Figure 7. After mounting the Switch (7) to the Bracket (8) with (2) (14) Screws, install the assembly as shown, but do not tighten the (2) (15)
Screws yet. Slide the assembly toward the Dump Door Arm (F) until you hear the switch "click" as the switch actuator contacts the Dump Door
Arm, then tighten the mounting Screws (15). NOTE: Make sure the switch is actuated(closed) before tightening the mounting Screws (15).
FIGURE 7
15
8
14
F
7
(page 6 of 8)
3/01 Form No. 56040742