Nilfisk-Advance Advance Retriever 2060 Service Manual page 123

WARNING!
DISCONNECT THE BATTERY BEFORE SERVICING.
1 Drain the cooling system.
Gasoline Engine Instructions:
2 See Figure 1. Remove Heater Hose (A) from the engine.
3 Using the heater hose from the kit, cut 2 pieces from it. One approximately 5 feet (152 cm) long and the other approximately 4 feet (122 cm) long.
NOTE: These lengths are approximate and may need to be adjusted.
4 Connect the 5' (152 cm) hose to port (B) and the 4' (122 cm) hose to port (C).
5 Cut the Conduit (7) into two appropriate lengths to cover the two heater hoses and slip over each hose.
FIGURE 1
Side View
B
A
© 2001 Printed in USA, Nilfisk-Advance, Inc.
56419405 HEATER KIT
For Retriever™ 2060 / SR 1800
CONTENTS OF KIT
ITEM PART NO.
56040752
1 56419250
2 56419364
3 56001856
4 56009012
5 56002701
6 56001939
7 56419366
8 56477613
9 56172230
INSTALLATION INSTRUCTIONS
C
QTY DESCRIPTION
1 Instruction Sheet
1 Heater Assembly
1 Bracket, Heater
2 Scr, Hex Hd 1/4-20 x 2.25
2 Scr, Hex Thd Form 10-24 x .38
3 Nut, Hex Nyl Loc 5/16-18
3 Wsh, Flt SAE 5/16
1 Conduit (8ft / 2.43 m)
8 Tie, Cable
1 Term. .25 Ins. Tab
Rear View
B
A
(page 1 of 4)
Heater
C
6/01 Form No. 56040752