Front Wheel Removal; Brake And Wheel Bearing Removal - Nilfisk-Advance Advance Retriever 2060 Service Manual

________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

FRONT WHEEL REMOVAL

1 Turn the key to OFF and set parking brake.
2 See Figure 3. Loosen lug nuts (C).
3 Jack up machine until wheel clears ground and place jack stand under machine.
4 Remove lug nuts (C) and remove wheel (D).
5 Reassemble in reverse order.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

BRAKE AND WHEEL BEARING REMOVAL

1 Follow steps 1-4 in wheel removal section.
2 Remove wheel cap (E).
3 Remove cotter pin (F).
4 Remove castle nut (G). NOTE: You will need a 1-1/2 inch socket.
5 Release parking brake.
WARNING!
Be sure machine is securely blocked.
6 Pull wheel hub (H) off brake assembly (I).
7 See figure 3, to access brakes and wheel bearings.
8 Reassemble in reverse order.
H
BRAKING / FRONT WHEEL SYSTEM
D
revised 8/00
FIGURE 3
F
C
I
FORM NO. 56043051 / Retriever
E
G
™ 2060 - 45