Nilfisk-Advance Advance Retriever 2060 Service Manual page 108

1 Disconnect the battery.
2 Open the left side door and the engine cover.
3 See Figure 1. Drain the Radiator and disconnect the (2) (A) Radiator Hoses and the overflow tank hose from the radiator.
4 Disconnect the (2) (B) Hydraulic Hoses from the oil cooler. Cap off these hoses to prevent leaking and from dirt entering the hydraulic system.
5 If your machine is either a propane or a dual fuel model, disconnect the propane line at the tank that goes through the small hole in the Rear
Weldment (C). After disconnecting, remove the fittings from the end of the hose and remove the P-Clamp holding the hose to the Rear Panel
Weldment (C). Pull the hose through the hole in the rear panel.
6 Remove the (6) (D) Screws (8 on propane machines) and the (2) (E) Screws and save for re-use.
7 Tilt the entire Rear Panel Assembly backwards to allow access to the cooling fan mounting screws. Remove these (3) screws and remove the
cooling fan.
8 Once the fan has been removed the entire rear panel assembly will lift up off of the machine.
D
© 2000 Printed in USA, Nilfisk-Advance, Inc.
56419303 4 TUBE RADIATOR KIT
™
For Retriever 2060 (gas, propane and dual fuel) without tip-up oil cooler
ITEM REF. NO.
56040732
1 56419287
2 56418227
3 56418605
4 56419277
5 56419306
INSTALLATION INSTRUCTIONS
B
A
Hole for
C
Propane Hose
CONTENTS OF KIT
QTY DESCRIPTION
1 Instruction Sheet
1 Shroud Weldment G
1 Hose, Lower Radiator
2 Gasket, Bulb
1 Radiator, 4 Tube
1 Bracket
FIGURE 1
D
E
(page 1 of 2) 9/00 Form No. 56040732