Nilfisk-Advance Advance Retriever 2060 Service Manual page 109

9 See Figure 2. Remove the (6) (F) Screws and (6) (G) Screws and save for re-use.
10 Remove Lower Radiator Hose (H) and save along with hose clamps for re-use.
11 Install the new Bulb Gaskets (3) to the new Shroud Weldment (1).
12 Mount the Bracket (5) and Shroud Weldment (1) to the new Radiator (4) using the original Screws (F).
13 Install the Lower Radiator Hose (H) between the Radiator (4) and the Shroud Weldment (1) using original hose clamps.
14 Mount New Radiator and shroud to Rear Panel (I) using original Screws (G).
15 Follow steps 3-8 in reverse order to re-install the Rear Panel Assembly onto the machine.
16 Fill radiator to proper level with appropriate engine coolant mixture. Remove radiator cap from old radiator and install on new unit.
17 Reconnect the battery and run the engine. Check coolant and hydraulic cooler hoses for any leakage.
G
I
F
Old Radiator and Shroud
G
FIGURE 2
G
New Radiator and Shroud
F
5
4
G
(page 2 of 2)
H
F
1
H
3
F
9/00 Form No. 56040732