Nilfisk-Advance Advance Retriever 2060 Service Manual page 93

1 Turn the machine off. Set the parking brake.
2 Use a hoist to lift the Overhead Guard (4) into position on the machine.
3 Position the Overhead Guard (4) so you can install Screw (1) and a Nut (2) as shown in the right-hand pre-drilled hole.
4 Make sure the rear mounting pad is flush with the back of the machine (not cocked to one side or the other). Using the Overhead Guard mounting
holes as templates, mark and drill the (3) mounting holes if your machine does not have pre-drilled holes.
5 Remove the (2) screws at the rear of the Control Panel and move it to the side for access to install two Nuts (2) and Washers (5), if your machine
doesn't have a nut plate welded in place. Install two item (3) Screws and two Nuts (6) and Washers (5). The nuts and washers are not needed
if your machine has a nut plate welded in place.
6 Re-install the Control Panel.
7 Raise the Hopper and secure with the hopper prop rod. Install the last item (3) Screw, Nut (2) and Washer (5) in the front mounting pad. Again
the nut and washer are not needed if your machine has a nut plate welded in place.
8 Lower the hopper and tighten all Screws (3). Install the (2) item (6) Gaskets on the right and left inside lips of the Overhead Guard top panel.
IMPORTANT!
Use only the hardware provided in the kit! Hardware strength is a factor in product safety.
© 2000 Nilfisk-Advance, Inc. Printed in USA
56418569 OVERHEAD GUARD KIT
For Advance Retriever
CONTENTS OF KIT
ITEM PART NO.
56040702
1 56001831
2 56002770
3 56003083
4 56418768
5 56001879
6 56418887
INSTALLATION INSTRUCTIONS
™ 2060 / Nilfisk SR 1800
QTY DESCRIPTION
1 Instruction Sheet
1 Scr, Hex Hd 1/2-13 x 1.25
4 Nut, Hex Nyl Loc 1/2-13
3 Scr, Hex Hd Loc 1/2-13 x 1.00
1 Overhead Guard Weldment
3 Wsh, Flt SAE 1/2
2 Gasket
(page 1) 6/99 revised 3/00 Form No. 56040702