Steer Wheel Removal - Nilfisk-Advance Advance Retriever 2060 Service Manual

HYDRAULIC SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
HOPPER UP CONTROL CABLE ADJUSTMENT
1 Observe the top speed of the machine with the
hopper in the lowered position. It should be ap-
proximately 9 MPH (14 kms/hour).
2 Raise the hopper and determine the top speed of
the machine, it should be about 25% of the top
speed with the hopper lowered or between 2-3
MPH (3-5 kms/hour).
3 See Figure 8. Loosen the two Bolts (T) and slide
the Cam Plate (U) to the right to increase the speed
or to the left to decrease the speed. Tighten the two
Bolts (T).
4 Repeat steps 1-3 until the speed of the machine
with the hopper raised is about 25% of the speed
with the hopper lowered.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

STEER WHEEL REMOVAL

WARNING!
Never work under a machine without safety blocks or stands to support the machine.
1 Turn steering wheel to left.
2 Turn off engine, set parking brake and block front wheels.
3 See Figure 9. Loosen the five wheel Lug Nuts (V).
4 If removing drive motor, remove Cotter Pin (W) and loosen center castle nut. NOTE: You will need a 1-7/16 inch socket for castle
nut.
5 Jack up machine until wheel clears ground and place jack stands under machine.
6 Remove Lug Nuts (V) and pull the wheel off the Hub Assembly (X).
FIGURE 9
Y
56 - FORM NO. 56043051 / Retriever
W
™ 2060
FRONT
L
U
X
Z
FIGURE 8
T
R
V