Nilfisk-Advance Advance Retriever 2060 Service Manual page 10

CONTROL PANEL DESCRIPTIONS
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
36 OIL PRESSURE GAUGE (OPTIONAL) – indicates the engine oil pressure while the engine is running.
37 BATTERY METER (OPTIONAL) – indicates the level of battery voltage and charging voltage.
38 FUEL GAUGE (GAS AND DUAL FUEL ONLY) – indicates the amount of fuel in the gasoline fuel tank.
39 HOUR METER – indicates the accumulated hours of usage.
40 DUST CONTROL SHAKER SWITCH – controls the vacuum system and the vacuum filter shaker. The vacuum system picks up
dust raised by the main broom. The filter shaker cleans the vacuum filter.
41 HEADLIGHT SWITCH – turns on the headlights.
42 ENGINE SPEED SWITCH – controls the speed of the engine. When operating the machine, the engine speed switch should be
in the full throttle position (lll).
43 DUMP DOOR INDICATOR LIGHT – indicates that dump door is closed or the hopper is raised.
44 CHECK ENGINE INDICATOR LIGHT (Currently N/A) – indicates a malfunction of the EFI system, shut off engine and have your
Nilfisk-Advance Service Center check the machine.
45 ENGINE TEMPERATURE INDICATOR LIGHT – indicates engine overheating, comes on at 225ºF (107° C), engine shuts itself
off at 235ºF (113° C). Turn key off and have your Nilfisk-Advance Service Center check the machine.
46 BATTERY INDICATOR LIGHT – indicates a charging system malfunction, shut off engine and have your Nilfisk-Advance Service
Center check the machine.
47 OIL PRESSURE INDICATOR LIGHT – indicates loss of engine oil pressure, 10 seconds after the light comes on, the engine will
shut itself off. Turn key off and have your Nilfisk-Advance Service Center check the machine.
48 DUST CONTROL FILTER INDICATOR LIGHT (OPTIONAL) – indicates when the dust control filter should be serviced.
49 HOPPER TEMPERATURE INDICATOR LIGHT (OPTIONAL) – indicates potential fire in the hopper.
50 HYDRAULIC FILTER INDICATOR LIGHT – indicates when the hydraulic oil filter should be serviced. Have your Nilfisk-Advance
Service Center check the machine.
51 PROPANE FUEL LOW INDICATOR LIGHT – indicates low propane fuel level.
52 IGNITION KEY SWITCH – controls the engine and some parts of the electrical system.
53 MAIN BROOM RAISE / LOWER (ON/OFF) LEVER – raises and lowers (stops and starts) the main sweeping broom. The sweep
position is for smooth floors. The full float position is for rough floors.
54 FUEL SELECTOR – found on dual fuel model only, to switch between propane and gasoline.
55 HOPPER RAISE/LOWER LEVER – controls the hydraulic cylinder that raises the hopper for dumping.
56 HOPPER DOOR OPEN / CLOSE LEVER – opens and closes the hopper dump door.
57 WATER TEMPERATURE GAUGE (OPTIONAL) – indicates the temperature of the engine coolant while the engine is running.
58 AIR FILTER SERVICE INDICATOR – Do not service the air filter unless the red flag is visible in the service indicator.
59 GLOW PLUG INDICATOR – for Diesel models (Currently N/A)
8 - FORM NO. 56043051 / Retriever ™ 2060