Impeller Motor Removal - Nilfisk-Advance Advance Retriever 2060 Service Manual

________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

IMPELLER MOTOR REMOVAL

WARNING!
Remove key and disconnect battery before servicing impeller.
1 Raise and support hopper cover.
2 See Figure 4. Raise and support shaker assembly and remove Filter (Q).
3 Remove 11 bolts from access cover and remove cover.
4 Remove three hoses to impeller Motor (R). Note: There may be oil in hoses and motor be prepared to cap motor and plug hoses.
Mark hose locations for reassembly.
5 Remove the four Bolts (S) from Impeller Bracket (T) and remove impeller assembly from machine.
6 Remove center Nut (U) and washer from impeller motor shaft and remove Impeller Fan (V).
7 Remove the four Nuts (W) from impeller bracket and remove motor from bracket.
8 Reassemble in reverse order. Note: Be sure the impeller assembly is mounted with the case drain (small hose) on motor facing
down.
W
FRONT
FIGURE 4
S
R
DUST CONTROL SYSTEM
Q
T
V
FORM NO. 56043051 / Retriever
U
™ 2060 - 35