Side Broom Switch Adjustment; Side Broom Motor Removal - Nilfisk-Advance Advance Retriever 2060 Service Manual

SWEEPING SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
SIDE BROOM SWITCH (S14) ADJUSTMENT
1 Remove four bolts on right side hopper panel, remove two screws holding latch in place. Remove the side panel.
2 Loosen the two bolts holding switch bracket in place.
3 Disconnect the two-wire connector on switch and insert continuity tester.
4 Adjust switch for no continuity when broom lever is in raised position and continuity when lever is in lowered position.
5 Tighten two bolts on switch bracket and reconnect two-wire connector. Check for proper operation.
6 Reinstall side panel and latch.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

SIDE BROOM MOTOR REMOVAL

1 See Figure 6. Remove side broom Thumbnut
(FF) and remove side broom from motor.
2 Remove the drive pin holding Hub (GG) on
motor shaft and remove drive hub.
3 Loosen the side broom adjustment Handle (HH)
and let side broom motor down to the lowest
position.
4 Remove and plug the two hydraulic hoses.
Note: Mark hoses for correct rotation when
reinstalling.
5 Remove two 1/2-13 Nuts (II) and Bolts (JJ), lift
and remove motor from bracket weldment (KK).
6 Reassemble in reverse order and check side
broom adjustment. (See side broom mainte-
nance section)
7 Test for proper operation and check for leaks.
18 - FORM NO. 56043051 / Retriever
FRONT
™ 2060
FIGURE 6
HH
KK
II
JJ
GG
FF