Engine System; Ford Engine Specs; Fuel Injection System; Engine Oil - Nilfisk-Advance Advance Retriever 2060 Service Manual

ENGINE SYSTEM

________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
ENGINE SPECIFICATIONS
Ford 4 Cylinder Gas/LP –model *VSG-413
Engine Type
Displacement
Fuel Gasoline
Fuel LP
Spark Plugs
Spark Plug Wiring
Engine Firing Order
Ignition timing
Valve Clearance (Cold)
Oil Capacity
Cooling capacity
*NOTE: Reference the separately supplied engine manufacture's Service and Operator manual for more detailed engine specification
and service data.
• Ford Engine Service manual P.N. PPD 194-294.
• Ford Maintenance & Operator manual P.N. 194-263.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

FUEL INJECTION SYSTEM

The 2060 / SR 1800 uses a ZEEMS (Zenith Electronic Engine Management System) throttle body fuel injection system to provide the
correct fuel/air mixture to the engine and to govern the engine idle speeds. Refer to the attached ZEEMS service manual for system
operation, maintenance and diagnostic procedures.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

ENGINE OIL

Oil Viscosity and type: Use the information below to choose the proper engine oil for the temperature where the machine is operated
most of the time. Use oil with an API rating SG, SG/CC or SG/CD.
• Above 60 °F (15 °C), USE 10W30 or 10W40
• Below 60 °F (15 °C), USE 5W30
Oil Filter: Use a Motorcraft FL-400A or equivalent, Nilfisk-Advance P.N. 56462862. Note: Change filter with each oil change.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

ENGINE AIR FILTER

Proper maintenance of the engine air filter is extremely important. The air filter should be serviced only when the indicator is lit.
The air filter assembly contains a primary element (outer) P.N. 56482029 and a safety (inner) filter element P.N. 56482028. The primary
element may be cleaned or replaced. The safety element should be replaced every third time the primary filter element is serviced. Never
attempt to clean and reuse the inner safety element.
To clean the primary element, remove the dust cup and the wing nut securing the primary element in place. Pull the element out of the
filter housing. Blow dust off of the element with compressed air (100 PSI, MAX.) or wash it with water (40 PSI, MAX.) Do not re-install
the filter element until it is completely dry. Also when servicing the air cleaner system, check the hose between the air filter and the
carburetor for loose clamps and any hose defects (cracks, kinks, holes etc.). Replace the hose immediately to prevent ingestion of
unfiltered air.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

ENGINE FUEL FILTER

Gasoline: Replace every 1,500 hrs. or once a year.
Propane: Replace every 1,500 hrs. or once a year.
46 - FORM NO. 56043051 / Retriever
Liquid Cooled, 4 Cylinder, Distributorless
79 cubic inches (1300 cc)
87 Octane Unleaded Gasoline
33 lbs. Tank Size (Liquid Withdraw System)
Plug Type Motorcraft AGRF 22CI, Gap .040 (1 mm)
Match Numbered Coil Position to Spark Plug Cylinder Number (front to rear 1,2,3&4)
1-2-4-3
Fixed
.008 inches (.2 mm) Lash Intake .020 inches (.5 mm) Exhaust
3.5 qt. (3.25 L) with filter change
8 qt. (7.6 L)
™ 2060