Side Broom Maintenance - Nilfisk-Advance Advance Retriever 2060 Service Manual

FIGURE 4
V
W
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
SIDE BROOM MAINTENANCE (CONTINUED)
Additional side broom adjustments
If you are unable to obtain the correct side broom pattern using the preceding steps there are two additional adjustments that could be
made (see fig. 5).
Side to side adjustment:
1 Loosen two (Z) Bolts.
2 Loosen Bolt (AA).
3 Adjust Plate (BB) for proper side to side angle.
Front to back adjustment:
1 Loosen Bolt (CC).
2 Loosen Bolt (DD).
3 Adjust Side Broom Bracket (EE) for proper front to back angle
adjustment.
NOTE: The machine should be stored with the Side Broom (13) in
the raised position. The Side Broom (13) should be replaced when
the bristles are worn to a length of 3 inches (7.62 cm) or it becomes
ineffective. The Side Broom stop must be re-adjusted whenever
the broom has been replaced.
To replace the Side Broom . . .
1 Put the Side Broom (13) in the UP position.
2 Reach under the Side Broom (13) and remove the large T-
Handle Nut holding the side broom on and remove the broom
and plastic disc.
3 Install the new broom and plastic disc by aligning the three
alignment pins and pushing on. Re-install the T-Handle Nut
and tighten.
X
17
DD
FORM NO. 56043051 / Retriever
SWEEPING SYSTEM
FIGURE 5
FRONT
AA
Z
EE
CC
Y
BB
Z
™ 2060 - 17