Nilfisk-Advance Advance Retriever 2060 Service Manual page 124

Propane / Dual Fuel Engine Instructions:
6 See Figure 2. Remove Heater Hose (D) from the
engine. Rotate Fitting (E) clockwise until it faces the
operator's compartment.
7 Using the heater hose from the kit, cut 2 pieces from
it. One approximately 3 feet (92 cm) long and the
other approximately 4 feet (122 cm) long. NOTE:
These lengths are approximate and may need to be
adjusted.
8 Connect the 3' (92 cm) hose to Fitting (E) and the 4'
(122 cm) hose to port (C) on the water pump (see
Figure 1).
9 Cut the Conduit (7) into two appropriate lengths to
cover the two heater hoses and slip over each hose.
Diesel Engine Instructions:
NOTE: For models without a fitting on Tube (G) you will
also need to order a new Radiator Tube PN 56419403 prior
to installing this kit.
10 See Figure 3. Remove Fitting (F) from the thermo-
stat housing. Install the straight fitting from the kit in
this port.
11 Remove Tube (G) if it does not have a plug fitting in it
and replace with new Tube PN 56419403. If your
machine already has the new tube with the plug, sim-
ply remove the plug. Install the valve from the kit in
this port, orientate as shown.
FIGURE 3
Straight
Fitting
D
Heater
FRONT
F
G
Valve
(page 2 of 4)
FRONT
E
12 Using the heater hose from the kit, cut 2
pieces from it. One approximately 5-1/2
feet (168 cm) long and the other approxi-
mately 4 feet (122 cm) long. NOTE: These
lengths are approximate and may need to
be adjusted.
13 Connect the 5-1/2' (168 cm) hose to the
valve on the lower radiator tube and the 4'
(122 cm) hose to the fitting in the thermo-
stat housing.
14 Cut the Conduit (7) into two appropriate
lengths to cover the two heater hoses and
slip over each hose.
FIGURE 2
Heater
6/01 Form No. 56040752