Pinion Gear Removal - Nilfisk-Advance Advance Retriever 2060 Service Manual

STEERING SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

PINION GEAR REMOVAL

WARNING!
Rear wheel must be on the ground when removing pinion gear.
1 Remove the four Bolts (Z) from Cover (AA) and remove cover.
2 Loosen the two Bolts (X) and slide the Rack (W) and adjuster Plate (Y) away from pinion Gear (V).
3 Remove the cotter pin and Castle Nut (BB) and loosen the two Set Screws (CC) on the pinion gear.
4 Use a gear puller to remove the pinion gear from the spindle shaft.
FIGURE 4
FRONT
W
42 - FORM NO. 56043051 / Retriever
S
U
X
Y
BB
V
DD
FF
™ 2060
T
Z
AA
CC
FF
EE
DD
GG
EE