Nilfisk-Advance Advance Retriever 2060 Service Manual page 83

WARNING!
DISCONNECT BATTERY BEFORE SERVICING.
1 Turn the key switch OFF and disconnect the battery.
2 Open the Side Access Door to access the Circuit Breaker Panel Assembly.
3 Mount the Time Delay (A) as shown with the (B) Screw and (C) Nut from the kit.
4 Directly above this location, hanging from the wiring harness are the wires needed to connect the Time Delay (A).
5 There is a tab connector with two Black wires connected to it and another with two Orange wires. A third with a Red/Blk wire and a fourth with a
Red/Brn wire. These last two will have a jumper wire between them, remove and discard this jumper wire.
6 Connect these wires to the Time Delay according to Figure 2.
7 Close Access Door and re-connect the battery.
8 Test the Time Delay for proper operation, the Shaker should remain
ON for 15 seconds after releasing the Shaker Switch.
FIGURE 2
TOP
BLK RED/BRN
© 1999 Nilfisk-Advance, Inc. Printed in USA
56418834 SHAKER TIMER KIT
For Advance 2060 / Nilfisk SR 1800
CONTENTS OF KIT
ITEM PART NO.
56040694
A 56491870
B 56002824
C 56002768
INSTALLATION INSTRUCTIONS
ORN
RED/BLK
QTY DESCRIPTION
1 Instruction Sheet
1 Time Delay
1 Scr, Pan Phil 10-24 x 1.25
1 Nut, Hex Nyl Loc 10-24
C
FIGURE 1
FRONT
4/99 Form No. 56040694
B
A