Starting The Engine - Nilfisk-Advance Advance Retriever 2060 Service Manual

________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
STARTING THE GASOLINE ENGINE
1 With the Engine Speed Switch (42) in the IDLE position ( l ), turn the Ignition Key Switch (52) clockwise to the START position and
release it as soon as the engine starts. If the engine does not start after cranking for 15 seconds, release the key, wait for 1 minute,
then try again.
2 Once started, let the engine run with the Throttle Control Switch in the IDLE ( l ) position for 5 minutes before using the machine.
3 Push the Throttle Control Switch to the FULL THROTTLE position ( lll )and move the machine around for 2 or 3 minutes at a slow
speed to warm up the hydraulic system.
ALWAYS operate the machine with the Throttle Control Switch at full throttle. Use the Forward/Reverse Pedal (16)
- not the Throttle Control Switch - to control the speed of the machine. The speed of the machine will increase as the pedal
is pushed closer to the floor. Do not press the Forward/Reverse Pedal until the engine has started, this will disengage the
starter if the optional Neutral Safety Switch is installed.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
STARTING THE PROPANE ENGINE
1 Open the service valve on the LP fuel tank (23).
2 With the Engine Speed Switch (42) in the IDLE position ( l ), turn the Ignition Key Switch (52) clockwise to the START position and
release it as soon as the engine starts. If the engine does not start after cranking for 15 seconds, release the key, wait for 1 minute,
then try again.
3 Once started, let the engine run with the Throttle Control Switch in the IDLE position ( l ) for 5 minutes before using the machine.
4 Push the Throttle Control Switch to the FULL THROTTLE position ( lll ) and move the machine around for 2 or 3 minutes at a slow
speed to warm up the hydraulic system.
ALWAYS operate the machine with the Throttle Control Switch at full throttle. Use the Forward/Reverse Pedal (16)
- not the Throttle Control Switch - to control the speed of the machine. The speed of the machine will increase as the pedal
is pushed closer to the floor. Do not press the Forward/Reverse Pedal until the engine has started, this will disengage the
starter if the optional Neutral Safety Switch is installed.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
STARTING THE DUAL FUEL ENGINE
1 The machine can be started using either fuel.
2 Select the desired fuel (54) and follow the starting procedure for that fuel.
3 In cold environments (below 32 degrees F / 0 degrees C) starting the unit on gasoline is recommended.
ALWAYS operate the machine with the Throttle Control Switch at full throttle. Use the Forward/Reverse Pedal (16)
- not the Throttle Control Switch - to control the speed of the machine. The speed of the machine will increase as the pedal
is pushed closer to the floor. Do not press the Forward/Reverse Pedal until the engine has started, this will disengage the
starter if the optional Neutral Safety Switch is installed.
ENGINE SYSTEM
FORM NO. 56043051 / Retriever ™ 2060 - 47