Nilfisk-Advance Advance Retriever 2060 Service Manual page 106

FIGURE 1
Install onto fan
inlet with bulb
toward inside.
13
3
1
5
15
14 Mount the Switch Bracket (20) to the inside of the cab with two screws (8).
15 Locate the two wires that come from the rear left corner of the cab. Connect these wires to one end of Switch (11). Attach the two wires from the
fan to the other end of the switch, so that the two black wires are across from each other.
16 Secure Switch (11) to its mounting bracket (20), by first removing the outer nut from the switch, then inserting the switch into the bracket hole,
replace the nut and tighten.
17 Place the 10 Amp Fuse (21) into the fuse block at the front of the cab. The fuse should go into the open slot were the wire colors going to it match
the wire colors from the cab's harness that you connected to the switch.
18 Reconnect battery and test once motor is running.
12
2
7
14
10
17
9
6
16
4
19
10
Trim 1.25" (3.2 cm) off this end of hose.
(page 2 of 3)
11
20
8
18
10
19
FRONT
5/00 Form No. 56040719
8