Neutral Start Switch - Nilfisk-Advance Advance Retriever 2060 Service Manual

ENGINE SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

NEUTRAL START SWITCH

A normally closed neutral start switch has been added to the propulsion pump arm. This switch will open the circuit to the starter solenoid
if the foot pedal is not in the neutral position when starting the engine.
To adjust:
1 With the engine running, assure that the foot pedal is in the neutral position and that there is no forward or reverse creep. Turn
the key switch to the off position.
2 See Figure 1. Loosen the two Bolts (A).
3 Move the Cam (B) until the ball on Switch (C) rests in the notch on Lever (D) without being depressed.
4 Tighten the two Bolts (A).
5 Test for proper operation by moving the foot pedal into the forward position then try to start the engine, the engine should not start.
Repeat this test with the foot pedal in the reverse position, the engine should not start. Allow the foot pedal to return to the neutral
position and try to start the engine, the engine should now start. Repeat steps 1-4 as needed until you obtain these results.
C
FRONT
48 - FORM NO. 56043051 / Retriever
D
D
A
C
™ 2060
FIGURE 1
B