Nilfisk-Advance Advance Retriever 2060 Service Manual page 101

Three wires from
Cord Assembly (Q)
Wht, Grn/Yel
& Blk
(19.3 mm)
24
28
25
FRONT
25 Raise the hopper enough to access the prop rod.
WARNING
When removing hopper prop do not rely solely on the hydraulic cylinder to support hopper. Support the hopper with some additional
means such as overhead hoist, stand etc.
26 See Figure 4. Remove Pull Rod (24) and its mounting hardware.
27 Loosen Set Screws (25) and then remove Screw (26). Slide out Hinge Pin (27) and don't lose Collar (28).
28 Drill the existing .281" (7mm) diameter hole in Prop Rod (29) to a 7/16" (11mm) diameter hole, and then tap the hole out to 1/2-13 UNC threads.
29 Place the prop rod back into the machine and fasten with original hardware items (25-28).
30 Install Prop Rod Handle (U) using two Hex Nuts (V) one on each side of the prop rod.
31 Lower the hopper.
H
2.25"
3.00"
ø .76"
V
29
V
U
FIGURE 4
3
Current
Position
3
New
Position
27
26
(page 4 of 7)
ø .172"
(4.4 mm)
FRONT
1.00"
2.38"
6.50"
Form No. 56040718