Tilt Steering Removal - Nilfisk-Advance Advance Retriever 2060 Service Manual

STEERING SYSTEM
FIGURE 1
B
E
C
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

TILT STEERING REMOVAL

1 See Figure 1. Remove the four Bolts (A) and remove Cover (B).
2 Remove Bolt (C) and Nut (D) then remove lower Spring Bracket (E) and Spring (F).
3 Remove the two Bolts (G) and Nuts (H) holding upper weldment to lower weldment.
4 Pull up on the steering Lock Lever (I) and lift the upper weldment off the lower weldment.
CAUTION!
Be careful not to damage hydraulic hoses.
5 You will now be able to access Lock Lever (I), Spring (J) and Latch (K).
6 To reassemble follow steps 1-4 in reverse order.
40 - FORM NO. 56043051 / Retriever
L
FRONT
A
O
H
I
F
G
™ 2060
M
N
J
P
D
K