16720A Pattern Generator (1-card module)
Each card shipped stand- alone has the 2 x 10 cable connected in the
single- card module configuration. A single- card module can be installed in
any available slot.
Turn off the mainframe power before removing, replacing, or installing modules. For
N O T E
instructions on installing modules into the logic analysis system frame, refer to
The order of pods on the card's rear panel is:
In a multi- card set, pods are indexed from the bottom up.
16900 Series Logic Analysis Systems Installation Guide
2x10 cable connection
for a single-card
Clk Pod
Installing Pattern Generator Cards
2x10 cable
Master
Pod 6
Pod 4
Pod 5
Pod 3
page
Pod 2
Pod 1
3
26.
71