Creating Simple Multiframe Configurations - Agilent Technologies 16900 Series Installation Manual

5
Setting Up Multiframe Configurations
• Choose one of the frames to run the Agilent Logic Analyzer application
• A network switch (as opposed to a hub) can be used to isolate traffic

Creating Simple Multiframe Configurations

1 Make sure all systems are connected to a common LAN in the same
2 Power off all logic analysis system frames.
3 Connect multiframe cable(s) between the chassis as shown.
88
on. If you only run the application on one frame, all your
configurations will be there (and will be easier to find). Also, there are
I/O and node- locked license file advantages when the application is run
on one frame (see "Other Multiframe Configuration Notes"
There will also be fewer popup warning messages when the Agilent
Logic Analyzer application on the slave systems are forced offline by
the multiframe connections.
between frames and improve performance, but it is not required.
way:
• All systems should be members of the same Domain, or they should
all be members of the same Workgroup. To get the systems properly
connected to the LAN, see
on page 77 or "To change network settings"
• It is highly recommended that the network and all systems be
configured to allow DHCP services to manage IP addressing.
Chapter 4, "First- Time Set Up," starting
16900 Series Logic Analysis Systems Installation Guide
on page 98).
on page 104.