To Install, Remove, Or Replace Measurement Modules - Agilent Technologies 16900 Series Installation Manual

2
Installing Logic Analyzer Cards and Probes

To install, remove, or replace measurement modules

If you ordered your measurement modules with the frame, they will
already be installed and you can skip this procedure.
If you are using a measurement module from a 16700 Series logic analysis
system you will need to replace the thumb screws. Begin with the
instructions on
The following procedure guides you through installing, removing, or
replacing measurement modules in the logic analysis system frame.
Information on connecting specific multi- card measurement modules is in
the next sections of this chapter. Measurement modules with different
model numbers cannot be connected together in multi- card
(Master/Expander) modules unless stated otherwise.
Electrostatic discharge can damage electronic components. Use grounded wrist straps
C A U T I O N
and mats when performing any service to measurement modules.
When removing cards that are connected together as multiple-card modules, be sure
C A U T I O N
to eject the multiple cards simultaneously, otherwise, the flex cables and/or
connectors could be damaged.
1 Power down the system and disconnect the power cable before
26
page 24.
installing, removing or replacing measurement modules.
16900 Series Logic Analysis Systems Installation Guide