Energy Saver Function; Sleep; Auto Sleep; Sleep Rules (Models For Europe) - Kyocera Taskalfa Pro 15000c Operation Manual

Installing and Setting up the Machine > Energy Saver Function

Energy Saver Function

If a further period of time elapses without the machine being used, the machine automatically enters Sleep Mode, which
minimizes power consumption.

Sleep

To enter Sleep, select the [Energy Saver] key. Touch panel and all indicators on the operation panel will go out to save
a maximum amount of power except the Energy Saver indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
To resume, perform the following actions.
• Select any key on the operation panel.
• Touch the touch panel.
• Place originals in the document processor.
• Open and close the document processor
Recovery time from Sleep Mode is as follows.
• 30 seconds or less
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.

Auto Sleep

Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The amount of time before entering Sleep is as follows.
• For Europe: 20 minutes (default setting)
• Except for Europe: 60 minutes (default setting)
To change the preset sleep time, refer to the following:
Quick Setup Wizard (page 3-13)
Sleep Timer (page 15-7)

Sleep Rules (models for Europe)

You can set whether Sleep Mode operates for each function. When the machine enters Sleep Mode, the ID card cannot
be recognized.
For more information on Sleep Rules settings, refer to the following:
Quick Setup Wizard (page 3-13)
Sleep Level (models except for Europe) (page 15-7)
Energy Saver indicator
3-9