Scanning > Sending Document to Folder on an FTP Server (Scan to FTP)
Sending Document to Folder on an FTP
Server (Scan to FTP)
Configuring Settings before Sending
Before sending a document, configure the FTP Client (Transmission).
Protocol Settings (page 15-50)
Sending Document to Folder on an FTP Server
1
2
3
4
[Home] key > [Send]
Place the originals.
Handling Destination (page 4-15)
In the basic screen for sending, select [+] > [FTP]
Enter the destination information.
Character Entry Method (page 4-8)
The table below lists the items to be set.
Item
Host Name
Host name or IP address of FTP server
You can also specify the port number. Enter the following format
separated by a colon.
"Host name: port number" or "IP address: port number"
To enter the IPv6 address, enclose the address in brackets [ ].
(Example: [2001:db8:a0b:12f0::10]:21)
If the port number is not specified in [Host Name], the default port
number is 21.
Port
Port number
If the port number is not specified, the default port number is 21.
Descriptions
11-9