Operating The Booms - Toro Multi Pro 5800-D Operator's Manual

5. Start the engine, set the parking brake, set the
pump switch to the O
throttle lever to
HIGH IDLE
6. Set the agitation switch to the O
Important:
Prior to introducing wettable
powders into any Toro Spray System,
mix the powders in a suitable container
with sufficient fresh water to create a free
flowing slurry. Failure to do so may result in
chemical deposits on the bottom of the tank,
degraded agitation, clogging of filters, and
improper agitation rates.
Toro recommends using the approved
Eductor Kit for this machine. Contact your
Authorized Toro Dealer for more information.
7. Add the proper amount of chemical concentrate
to the tank, as directed by the chemical
manufacturer.
8. Add the remaining water to the tank.

Operating the Booms

The boom-lift switches on the sprayer control
panel allows you to move the booms between the
T and S
RANSPORT PRAY
operator's seat. It is recommended to change the
boom positions while the machine is not moving.
1. Stop the sprayer on level ground.
2. Use the boom-lift switches to lower the booms.
Note:
Wait until the booms reach the full,
extended spray position.
3. When you need to retract the booms, stop the
sprayer on level ground.
4. Use the boom-lift switches to raise the booms.
Note:
Raise the booms until they are completely
in the boom-transport cradle forming the 'X'
transport position and the boom cylinders are
fully retracted.
Important:
To prevent damage to the
boom-actuator cylinder, make sure that the
actuators are fully retracted before transport.
Important:
Release the actuator switch once
the booms have reached the desired position.
Running the actuators against the stops may
damage the cylinders and/or other hydraulic
components.
Operating the Boom-Transport
Cradle
The sprayer comes with a boom-transport cradle that
has a unique safety feature. In the event of accidental
position, and move the
N
.
position.
N
positions without leaving the
boom contact with a low overhead object while in the
T position, you can push the boom(s) out of
RANSPORT
the transport cradles. If this occurs, the booms will
come to rest in a near horizontal position to the rear
of the vehicle. From this position, move the booms to
the transport cradle immediately.
Important:
Transporting the booms in any
position other than the 'X' transport position using
the boom-transport cradle can damage the booms.
To put the booms back into the transport cradle, lower
the boom(s) to the S
boom(s) back into the T
that the boom cylinders are fully retracted to prevent
actuator-rod damage during storage.
30
position, and then raise the
PRAY
position. Ensure
RANSPORT