Replacing A Transceiver Module; Replacing An Xfp/Sfp+/Sfp/Qsfp+ Module; Replacing A Cfp Module - H3C SecPath M9000 Series Manual

Replacing a transceiver module

WARNING!
When you install or remove a transceiver module:
• Do not stare at the fibers to avoid hurting your eyes.
• Do not touch the golden plating on the module.
Make sure the optical transceiver modules at the two ends of an optical fiber are the same model. In
case of limited space, you can use the supplied tweezers to install or remove a transceiver module
as a best practice.

Replacing an XFP/SFP+/SFP/QSFP+ module

Remove the optical connectors on the module.
1.
Pivot the clasp down to the horizontal position.
2.
For a QSFP+ module that uses a plastic pull latch, skip this step. QSFP+ modules use either a
metal or plastic pull latch.
Grasp the clasp on the module and carefully pull the module out of the slot.
3.
Put the filler plug on the removed module, and put the remove module into its original shipping
4.
materials.
Install a new module.
5.
For the installation procedures, see "Installing an XFP/SFP+/SFP/QSFP+ transceiver module."

Replacing a CFP module

Wear an ESD wrist strap and make sure it makes good skin contact and is correctly grounded.
1.
For more information, see "Attaching an ESD wrist strap."
Remove the optical fiber from the module.
2.
Loosen the captive screws on the module.
3.
Carefully pull the module out of the slot.
4.
Insert the dust plug into the removed module, and put the removed module into its original
5.
package (recommended) or an antistatic bag.
Install a new CFP module.
6.
For the installation procedures, see "Installing a CFP module."
39