Attaching Air Filters To An M9006/M9014 Gateway; Attaching Air Filters To An M9010/M9010-Gm Gateway - H3C SecPath M9000 Series Manual

Attaching air filters to an M9006/M9014 gateway

Air filters of an M9006/M9014 gateway are installed at the left of the chassis. The air filter installation
procedures on an M9006 and M9014 are the same.
To install an air filter on an M9006/M9014 gateway:
Put the air filter near the air inlet vents on the left of the chassis and insert the poisoning pins on
1.
the air filter into the corresponding holes on the chassis.
Insert the screws into the screw holes on the air filter, and fasten them with a Phillips
2.
screwdriver.
Figure 11 Attaching air filters to an M9006 gateway
2
1
2

Attaching air filters to an M9010/M9010-GM gateway

The air filter of an M9010 or M9010-GM gateway is installed at the lower part of the chassis front.
To install an air filter on an M9010 gateway:
Put the air filter near the air inlet vent on the lower part of the chassis front and insert the
1.
poisoning pins on the air filter into the corresponding holes on the chassis.
Insert the screws into the screw holes on the air filter, and fasten them with a Phillips
2.
screwdriver.
1
14