Appendix C Leds; Mpu Leds - H3C SecPath M9000 Series Manual

Appendix C LEDs

The M9000 gateway series provides a lot of LEDs. You can determine the gateway operating status
by examining the LEDs.

MPU LEDs

Figure 41 shows the LEDs on the MPU.
Figure 41 MPU LEDs
(1) Management Ethernet port LEDs
(3) Card status LEDs
Management Ethernet port LEDs
Each MPU has one LINK LED and one ACT LED to indicate the link status and data forwarding
status of the management Ethernet port.
Table 32 Management Ethernet port LED description
LINK
Steady on
Steady on
Off
Fan LEDs
Each MPU provides one OK LED and one FAIL LED for a fan tray.
•
The M9006, M9010, and M9010-GM gateways each have one fan tray. The LEDs for the fan
tray is FAN0.
•
The M9014 gateway has two fan trays. The LEDs for the fan trays are FAN0 and FAN1.
Table 33 Fan LED description
OK
Steady on
Off
Off
Card LEDs
Each MPU has the LEDs numbered the same as card slots to indicate the status of the active MPU,
standby MPU, interface modules, service modules, and switching fabric modules in the slots.
34 shows the LED description.
ACT
Flashing
Off
Off
FAIL Description
Off The fan tray is operating correctly.
Steady on The fan tray has failed or is not present.
Off The gateway is not powered on.
(2) Fan LEDs
(4) MPU active/standby status LED
Description
A link is present, and the management Ethernet port is receiving
or sending data.
A link is present.
No link is present.
60
Table