Installing Mounting Brackets; (Optional) Installing Air Filters - H3C SecPath M9000 Series Manual

Figure 9 Attaching the power cord management bracket to an M9006 gateway
(1) Place the cable management bracket against the installation position on the chassis
(2) Screw holes for installing the cable management bracket
(3) Screws for attaching the cable management bracket to the chassis
(4) Power cord management bracket

Installing mounting brackets

Before installing the gateway to the rack, install the mounting brackets to the chassis. Marks L and R
are printed inside the mounting brackets to distinguish between the left and right mounting brackets.
To install the mounting brackets, face the front of the gateway, and attach the left and right mounting
brackets to the two sides of the gateway, as shown in
Figure 10 Installing the mounting brackets to an M9006 gateway
(1) Screws for attaching the mounting brackets to the chassis
(3) Signal cable management brackets

(Optional) Installing air filters

Air filters are installed at the air inlet vents to prevent dust from entering the chassis. If you have
ordered air filters, install the air filters before mounting the gateway to the rack.
Figure 10.
13
(2) Mounting brackets