Installing A Power Module - H3C SecPath M9000 Series Manual

Installing a power module

CAUTION:
• Do not install AC power modules and DC power modules on the same gateway.
• Select power modules according to the power supply at the installation site.
• Provide a circuit breaker for each power module and make sure the circuit breaker is off before
installing the power module.
Some power module slots do not have a blank filler panel. The figures in this section are for
illustration only.
An AC power module and a DC power module are installed in the same way. This section uses an
AC power module as an example.
To install the power module:
Use a Phillips screwdriver to loosen the captive screws on the blank filler panel (if any) to
1.
remove the blank filler panel.
Follow the installation graph printed on the blank filler panel of the power module to install the
2.
power module in a correct direction:
a. Grasp the handle of the module with one hand and support the module bottom with the
other.
b. Push the power module along the guide rails into the slot until it has firm contact with the
slot.
For vertical slot installation, see
Press the handle inward until the handle seats into the slot.
3.
Use a Phillips screwdriver to fasten the captive screw on the handle to attach the power
4.
module.
Figure 18 Installing a power module in a vertical slot (M9010/M9010-GM/M9014)
Figure 18. For horizontal slot installation, see
19
Figure 19.