Replacing A Transceiver Module - H3C MSR3610-I-DP Installation Manual

Figure 17 Removing the hard disk
1

Replacing a transceiver module

WARNING!
Disconnected optical fibers or transceiver modules might emit invisible laser light. Do not stare into
beams or view directly with optical instruments when the switch is operating.
CAUTION:
Make sure the transceiver modules connected by a fiber have the same specifications.
To replace a transceiver module:
Disconnect the fiber from the transceiver module.
1.
Rotate downward the bail latch of the transceiver module to the horizontal position, and then
2.
pull the transceiver module out of the port.
You can use a pair of tweezers to remove the transceiver module.
Install a dust plug into each transceiver module port.
3.
Install a new transceiver module. For information about the installation procedure, see
4.
"Connecting a fiber port."
If you are not to install a new transceiver module, install a dust plug into the empty fiber port.
Figure 18 Removing a transceiver module
2
22