Table of Contents
Advertisement
If you are not to install a new SIC, install a filler panel in the slot and fasten the screws on the
filler panel.
Figure3-3 Removing a SIC
1
Replacing an M.2 SSD drive
1.
Remove the SIC-M2-SATA riser module. For more information about removing an
SIC-M2-SATA riser module, see
2.
Use a Phillips screwdriver to remove the fastening screw that secures the M.2 SSD drive to the
riser module.
3.
Lift the M.2 SSD drive to an angle of 45 degrees and then pull the drive slowly out of the M.2 slot
on the SIC-M2-SATA riser module.
Keep the removed M.2 SSD drive secure for future use.
4.
Install a new M.2 SSD drive. For more information about installing an M.2 SSD drive, see
"Installing an M.2 SSD
Figure3-4 Removing an M.2 SSD drive
Replacing a transceiver module
WARNING!
Disconnected optical fibers or transceiver modules might emit invisible laser light. Do not stare into
beams or view directly with optical instruments when the switch is operating.
CAUTION:
Make sure the transceiver modules connected by a fiber have the same specifications.
To replace a transceiver module:
2
''Replacing a SIC interface
drive."
1
23
module."
3
2
Advertisement
Table of Contents
