Henny Penny KFC Velocity Series Operation Manual page 56

After the initial installation of the fryer and during every oil change, the vat must be
thoroughly cleaned. There are two ways to clean the vat using the clean-out mode,
heated and cold soak. Operators can fill the vat with warm water and cleaning
solution, enable heat, and then scrub the vat immediately (P.M.) or let it soak
overnight cold and scrub it in the morning (A.M.). Cleaning the vat immediately is
called a Heated Clean-Out and allowing the vat to soak overnight is called a Cold-
Soak Clean-Out. The choice of which type of clean-out an operator uses is set during
installation within the software settings. Refer to Drain and dispose of the oil before
performing these procedures. Refer to
6 6 . . 7 7 . . 1 1 S S e e t t t t i i n n g g t t h h e e C C l l e e a a n n - - O O u u t t M M o o d d e e T T y y p p e e
Operators can choose between a Heated and a Cold-Soak clean-out. To select a
clean-out mode refer to
6 6 . . 7 7 . . 2 2 C C l l e e a a n n - - O O u u t t M M e e n n u u O O v v e e r r v v i i e e w w
Select the 1. FILTER menu, and then press the Main menu button twice to select 8.
CLEAN-OUT and perform clean out tasks.
M M e e n n u u ( ( s s c c r r e e e e n n ) ) 1 1
6 6 . . 7 7 . . 3 3 A A c c c c e e s s s s C C l l e e a a n n - - O O u u t t M M o o d d e e
Use the following steps to access the Clean-Out menu. An indicator light displays next
to active options during procedure.
If necessary, drain and dispose of the old unusable oil. Refer to
1 1 ) )
page 37
Press and hold the M M a a i i n n menu button until *MAIN* displays. The Main menu
2 2 ) )
displays.
Press the 1 1 . . F F I I L L T T E E R R button. Additional menu items display.
3 3 ) )
Press the M M a a i i n n menu button twice. The 8. CLEAN-OUT menu displays.
4 4 ) )
Press the 8 8 . . C C L L E E A A N N - - O O U U T T button. =CLEAN OUT= HAS OIL BEEN REMOVED?
5 5 ) )
YES NO displays.
Press Y Y E E S S . IS VAT FILLED WITH WATER & CLEANER? displays.
6 6 ) )
Proceed to
7 7 ) )
6 6 . . 7 7 . . 4 4 P P e e r r f f o o r r m m t t h h e e C C l l e e a a n n - - O O u u t t P P r r e e p p a a r r a a t t i i o o n n
Remove the racks and carrier.
1 1 ) )
46
7.5 Special Programming , page
M M e e n n u u ( ( s s c c r r e e e e n n ) ) 2 2
for instructions.
6.7.4 Perform the Clean-Out Preparation , page 46
6.6 Oil Disposal , page 37
59, SP-22 through SP-24.
M M e e n n u u ( ( s s c c r r e e e e n n ) ) 3 3
for instructions.
M M e e n n u u ( ( s s c c r r e e e e n n ) ) 4 4
6.6 Oil Disposal ,
.